Measurement Configuration
Level Adjustment
Adjust the level of the measurement signal that is played back for measurement.
Input Level
-60
-48
-36
-24
-12
0
Play the test signal and adjust the microphone gain so that the input level is between -36dB and -6dB.
Input too high! Reduce microphone gain or speaker volume.
Frequency Response Measurement
Input Level
The measurement signal for one extra measurement plus the number of measurements is reproduced.
Current Measurement
Click Redo to discard this measurement and measure again.
Click Save and Measure Another Point to save this measurement and measure another point to improve the correction accuracy (measurement starts immediately after clicking the button).
Click Save and Finish to accept this measurement and complete the measurement.
No measurements available. Click "New Measurement" to begin.
Measurement Results
Measurement Points
Frequency Response
0.3 oct.
Amount of frequency response smoothing to adjust sensitivity to peaks and dips.
20 Hz
The lower limit frequency for frequency response correction. It is usually best to set it at the lower limit of the system's playback capabilities.
20000 Hz
The upper frequency limit for frequency response correction. It is recommended to determine this based on the upper frequency limit of the measurement microphone.
5 Band
The number of bands of the parametric equalizer for correction. The more bands you have, the more detailed the frequency correction will be, but the processing load will increase.
The copied frequency correction settings can be pasted into EffeTune's Effect Pipeline by Ctrl+V.